I like to set WCS to ‘model orientation’, ‘stock box point’, and then choose the lower-left corner of my stock box as illustrated here.You could also enter your actual stock size if desired, but this merely serves as a visual reference perhaps as a double-check of your part layout. Feed settings: don’t matter in our case.Kerf width: more on this later choose.cutting mode: ‘Through – auto’ (I’m not sure what this does but it sounds logical and worked for me).Click OK to finish the setup, then click ‘WATERJET’ to create a new contour operation, and set values on each tab as follows.This works the same as for milling operations. It seems that these must be selected individually, which is a pain in the neck for a complex project. These values don’t matter, since we’re going to remove the movement paths at post-process time.You can also set up ‘tabs’ here, if desired.When selecting contours, note that a red arrow is displayed illustrating the cut direction.
#Slicer for fusion 360 says material is too small install#.
0 kommentar(er)
